Order by Depth – Fusion 360 – 2D Contour (part 18)
Order by Depth Fusion 360 Order by Depth In the case of machining several separate parts segments, we can determine in which order
[...]
Fusion 360
Rough Final – Fusion 360 – 2D Contour (part 17)
Rough Final Fusion 360 Rough Final is another parameter that applies in a specific situation. If we use Roughing Passes and the Finishing
[...]
Finish Only at Final Depth – Fusion 360 – 2D Contour (part 16)
Finish Only at Final Depth Fusion 360 Another parameter in the Multiple Depths section, in the Passes tab, in the 2D Contour operation
[...]
Wall Taper Angle – Fusion 360 – 2D Contour (part 15)
Wall Taper Angle Fusion 360 If we would like to mill the wall and give it a tilt, we can use the Wall
[...]
Finishing Stepdowns – Fusion 360 – 2D Contour (part 14)
Finishing Stepdowns Fusion 360 Finishing Stepdowns, another parameter of the Passes tab in the 2D Contour. Using this parameter, we can add a
[...]
Multiple Depths – Fusion 360 – 2D Contour (part 13)
Multiple Depths Fusion 360 The next section in the Passes tab for contour machining is the Multiple Depths section. We can divide the
[...]
Roughing Passes– Fusion 360 – 2D Contour (part 12)
Roughing Passes in 2D Contour machining The next section in the Passes tab in the 2D Contour operation is the Roughing Passes section.
[...]
Extension toolpath – Fusion 360 – 2D Contour (part 11)
Tangential Fragment Extension Distance Another parameter that will allow to adjust the passes is the Tangential Fragment Extension Distance parameter. This option is
[...]
Outer Corner Mode – Fusion 360 – 2D Contour (part 10)
Outer Corner Mode and Adjusting passes – Fusion 360 2D Contour Another parameter that will allow you to adjust the passes is Lead
[...]
Better Surface Finish – Fusion 360 – 2D Contour (part 9)
Better surface finish after 2D Contour Additional finishing passes can be adjusted to get a better surface finish. The Leads on all Finishing
[...]