3D Engraving in Alphacam
3D Engraving in Alphacam
Hi,
There is new video about engraving in Alphacam!
YouTube: https://youtu.be/h95ETh1giPs
Hi,
There is new video about engraving in Alphacam!
YouTube: https://youtu.be/h95ETh1giPs
Initial Stock– Alphacam YouTube: https://youtu.be/KJxvCJVJqrs The next parameter in the Machining Data tab is the Initial Stock parameter. This is the finishing allowance that has remained after the previous machining. The pre-field of this parameter is blanked. To activate this, in the Stock Removal section, we must specify Number of Cuts for machining this allowance….
Alphacam for Dummies – Lesson 9 Subscribe me on YouTube! YouTube: https://youtu.be/fnmeiXDwHwo Let’s edit the last operation – Pocketing. And select Machining Data tab. In this case, the first two parameters will be important. Stock to be Left, this parameter determines how much material will remain after machining (after this operation). This is the on…
Alphacam Rough or Finish – Contour machining in Alphacam In this lesson we will discuss Z levels form Levels and Cuts Tab from Rough or Finish operation. This operation will allws us to machine Alphacam geometries eg. Lines or rectangles… This produce tool path along the contour. Let’s check the Z Levels from Levels and Cuts Tab Safe Rapid Level The Z level that the tool can safely traverse the machining area at a rapid speed. Rapid Down To The Z level that the tool can move down to at a rapid speed. Material Top The Z level of the top of the material to be machined. Final Depth The Z level at which the tool will make its final pass. In the video you will get more information. Please see the video on YouTube!
How to draw a rectangle in Alphacam? In the last lesson we discussed the Line command. Now we will discuss the Rectangle command. The rectangle is another basic shape. Of course, we could get a rectangle using the Line command, but it would take much longer. To draw a rectangle, select the Rectangle option from…
Alphacam Postprocessor YouTube: https://youtu.be/Ve-_FRUdxoM This post is only intended to provide information on what a postprocessor is. As part of this course, we will not be involved in the creation of post-processors. I just want to show what the postprocessor looks like in Alphacam and how it is built. By default, for the Alphacam Router…
Contour machining part 2 – General tab – Alphacam YouTube: https://youtu.be/L3vXdvm8ihM On the Types tab, select the Vertical option and go to the General tab. In the Tool section we have information about which tool we have selected for this operation and here we can also change the selected tool. The Compensation section is responsible…