Leads & Transitions Fusion 360 – 2D Contour (part 23)

Leads & Transitions Fusion 360 – 2D Contour (part 23)

Leads & Transitions Fusion 360 Another section in the Linking tab is the Leads & Transitions. Section for tool entry ant tool exit. To apply a specific tool entry to the material, we need to select the Lead-In (Entry) option. After marking it, we can specify the radius of the horizontal arc (Horizontal Lead-In Radius),…

Extension toolpath – Fusion 360 – 2D Contour (part 11)
|

Extension toolpath – Fusion 360 – 2D Contour (part 11)

Tangential Fragment Extension Distance Another parameter that will allow to adjust the passes is the Tangential Fragment Extension Distance parameter. This option is rateher applicable to open contours. The tool path wusing this option will look like the picture below. Without using this option, the tool path will look like in the picture below. You…

Outer Corner Mode – Fusion 360 – 2D Contour (part 10)
|

Outer Corner Mode – Fusion 360 – 2D Contour (part 10)

Outer Corner Mode and Adjusting passes – Fusion 360 2D Contour Another parameter that will allow you to adjust the passes is Lead End Distance. This parameter will cause that at the end of the pass (at the distance from the end of the pass, specified in this parameter) the feedrate will be changed to…

Better Surface Finish – Fusion 360 – 2D Contour (part 9)
|

Better Surface Finish – Fusion 360 – 2D Contour (part 9)

Better surface finish after 2D Contour Additional finishing passes can be adjusted to get a better surface finish. The Leads on all Finishing Passes will add the tool in and tool out to each pass. When this option is unselected, we will get something like: As in any case, so in this, you have to…