Lead In/Out – Line – Alphacam #41
|

Lead In/Out – Line – Alphacam #41

If you find my tutorials helpful, you can support CADCAMLessons: https://ko-fi.com/cadcamlessons Lead In/Out – Line – Alphacam YouTube: https://youtu.be/TRjahOTbe5E Before we run the simulation, based on the appearance of the tool paths, we could see that the tool’s entry into the material is not very good. We see that the tool goes down vertically. As…

Contour machining part 11 – Remove from operation – Alphacam #31
|

Contour machining part 11 – Remove from operation – Alphacam #31

If you find my tutorials helpful, you can support CADCAMLessons: https://ko-fi.com/cadcamlessons Remove from operation – Alphacam YouTube: https://youtu.be/RS34kL0ryf4 In the previous post I showed how to add geometry to the operation, for example in a situation where we did not select all geometries and confirmed the choice or when we just added a geometry and…

Contour machining part 10 – Add Geometries – Alphacam #30
|

Contour machining part 10 – Add Geometries – Alphacam #30

If you find my tutorials helpful, you can support CADCAMLessons: https://ko-fi.com/cadcamlessons Add Geometries – Alphacam YouTube: https://youtu.be/g-2wUrql4Tg When preparing the contour machining, we do not have to create a separate strategy for each contour that we want to work with. If we plan to machine several contours at the same depth, we can do it…

Contour machining part 1 – Rough or Finish – Alphacam #21
|

Contour machining part 1 – Rough or Finish – Alphacam #21

If you find my tutorials helpful, you can support CADCAMLessons: https://ko-fi.com/cadcamlessons Contour machining part 1 – Rough or finish – Alphacam YouTube: https://youtu.be/M7RXJq12MJw Most of the functions related to tool paths can be found in the Machine tab. Before we select the tool, the machining strategies are dimmed, only after the tool has been selected,…