Rough Final – Fusion 360 – 2D Contour (part 17)
|

Rough Final – Fusion 360 – 2D Contour (part 17)

Rough Final Fusion 360 Rough Final is another parameter that applies in a specific situation. If we use Roughing Passes and the Finishing Stepdowns parameter in the Multiple Depths section, then in the case of configuration of parameters such as in the picture above, we will get the toolpaths as in the picture below. This…

Finish Only at Final Depth – Fusion 360 – 2D Contour (part 16)
|

Finish Only at Final Depth – Fusion 360 – 2D Contour (part 16)

Finish Only at Final Depth Fusion 360 Another parameter in the Multiple Depths section, in the Passes tab, in the 2D Contour operation is the parameter Finish Only at Final Depth. In order to notice the operation of this parameter, we must first specify the Number of Finishing Passes and the step of finishing passes…

Finishing Stepdowns – Fusion 360 – 2D Contour (part 14)
|

Finishing Stepdowns – Fusion 360 – 2D Contour (part 14)

Finishing Stepdowns Fusion 360 Finishing Stepdowns, another parameter of the Passes tab in the 2D Contour. Using this parameter, we can add a specific number of finishing passes with a specified depth. By entering 2 in the Finishing Stepdowns parameter and entering 1 in the Finishing Stepdown parameter, we will get: In the NC code…

Multiple Depths – Fusion 360 – 2D Contour (part 13)
|

Multiple Depths – Fusion 360 – 2D Contour (part 13)

Multiple Depths Fusion 360 The next section in the Passes tab for contour machining is the Multiple Depths section. We can divide the contour processing into several Z-axis passes, and separate the roughing and finishing operations. Let’s check the next parameters on the examples. The first parameter is the Maximum Roughing Stepdown. This is the…

Roughing Passes– Fusion 360 – 2D Contour (part 12)
|

Roughing Passes– Fusion 360 – 2D Contour (part 12)

Roughing Passes in 2D Contour machining The next section in the Passes tab in the 2D Contour operation is the Roughing Passes section. This section is responsible for the additional, roughing passes in the contour machining. Maximum Stepover The first parameter is the Maximum Stepover. this is the maximum step of passes. This is the…

Sideways Compensation – Fusion 360 – 2D Contour (part 5)
|

Sideways Compensation – Fusion 360 – 2D Contour (part 5)

Sideways Compensation – Passes Tab Fusion 360 YouTube: https://youtu.be/7HTTUc8fM14 Next tab in 2D Contour is Passes. Compared to the Passes tab from the Face operation, we have a lot more parameters here that will affect the machining. The first of them, Tolerance, has already been described and is responsible for the accuracy of interpolating arcs using…